Yes the non SAS wheel will be narrower. The camera should push all the way to the end of the new housing & snap into place once you remove it form the factory housing. You can also adjust the new housing section closer to the swing gate if the camera cable is too short.Just installed mine today! Had Help, Needed it. Happy as it fixed the clunk pop in my tail gate when going over bumps. I do have an issue though and I am sure it is an oversight. Seems non SAS or maybe just Big bend have a different camera (length) the housing they provide is 3 inches to long so the camera "See's" the housing and it cuts the rear view substantially, will post a pic below.
What license plate mount is that? Did it work well. Awaiting arrival of this bumper and I don’t like the look of relocating the plate to the tire.Installed mine about a week ago. Parking sensors work, backup cam works but was a pain to get out of factory housing, modified third brake light to work lastly the license plate bracket that came with is less than desirable. I ended up buying a DV8 license plate bracket that works great and has a light included, routed wiring thru tailgate along with all factory wiring. As for the bumper itself build quality seems really good, finish on the tire mounting brackets is not so great I’m already seeing rust form along two welds after one week of PNW weather. Also don’t bother ordering the Expo one Geri can and mount. They can only ship white and black cans to a US address and the can mounting points do not align with Rotopax mount points.
