- Thread starter
- #1
Hello fellow Bronco enthusiasts,
I recently purchased a Procal4 for my Bronco, and I'm having some issues with the upgrade process when connecting it to my PC. I was hoping to get some advice and insights from the community here.
Issue: When I connect my Procal4 to my PC, I am unable to perform the upgrade as intended. The software doesn't seem to work as expected, and I'm at a loss as to what might be causing the problem.
What I've Tried So Far:
I've followed the instructions provided with the Procal4 to the letter.
I've ensured that my PC meets the system requirements.
I've checked for any driver updates, but everything seems up-to-date.
I've attempted the process multiple times, but with no success.
Questions:
Has anyone else encountered a similar issue with their Procal4 and PC connection?
Are there any troubleshooting steps or tips you can share to help me resolve this problem?
Is there any specific software or firmware I should be aware of to make the upgrade smoother?
I appreciate any guidance or advice you can offer. Your experience and expertise will be invaluable in helping me get my Bronco up and running with the Procal4. Thank you in advance for your assistance!
I recently purchased a Procal4 for my Bronco, and I'm having some issues with the upgrade process when connecting it to my PC. I was hoping to get some advice and insights from the community here.
Issue: When I connect my Procal4 to my PC, I am unable to perform the upgrade as intended. The software doesn't seem to work as expected, and I'm at a loss as to what might be causing the problem.
What I've Tried So Far:
I've followed the instructions provided with the Procal4 to the letter.
I've ensured that my PC meets the system requirements.
I've checked for any driver updates, but everything seems up-to-date.
I've attempted the process multiple times, but with no success.
Questions:
Has anyone else encountered a similar issue with their Procal4 and PC connection?
Are there any troubleshooting steps or tips you can share to help me resolve this problem?
Is there any specific software or firmware I should be aware of to make the upgrade smoother?
I appreciate any guidance or advice you can offer. Your experience and expertise will be invaluable in helping me get my Bronco up and running with the Procal4. Thank you in advance for your assistance!
Sponsored
Last edited: