We have a hard-top Bronco coming in next week for additional testing. As for disconnects no. Although the rack can be used for various load options, its initial design was for installing a tent which makes it a handful for disconnects.
@ZROADZOFFICIAL do you provide foam and or PPF to protect the paint in your kits? How about an install video (Iāve searched around and couldnāt find one for the soft top)? Also the bronco6g code didnāt seem to work last I checked.
No video yet and there is a gasket included in the kit for the top edge of the 1/4 panel. Just checked the promo code and it's active. Use promo code BRONCO6G
Thank you for the feedback!
Technically you could. The issue is that the front bracket sits at the accessory portion of the windshield plus has an approx. extension of 6 inches that slips into the longitudianl bars and is held in place with a boltCan't wait to hear if it works with the hard top.
Is it possible to disconnect at this point so that you can remove the rack and retain the light bar? That would allow for top less running while keeping the light bar attachment.
Do you plan on installing a Roof top Tent? And if so how big/long??
We forgot to ask, did you plan on installing a Roof top Tent? And if so how big/long??
Not planning on installing a roof top tent. The rear being able to open and prop up is a must. I already ordered the JCR soft top roof rack, but thanks for checking in.
@ZROADZOFFICIAL What are the dimensions of the cross bars (Looked on the website)? I have a yakima sky rise tent, and want to make sure it will fit. The feet only expand so far. Thanks in advance.
The front crossbar has an approx width of 3 inches while the rear crossbars are at 4". Both front and rear have multiple holes and slots as well that should accommodate almost ant accessory
