i like. can i ask where you got it?Replaced the OEM Badlands badge with a pair I found on Etsy. I think they look real good.
Sponsored
Last edited:
i like. can i ask where you got it?Replaced the OEM Badlands badge with a pair I found on Etsy. I think they look real good.
Oh I like these too. Are they the same size as the OEM ones?Replaced the OEM Badlands badge with a pair I found on Etsy. I think they look real good.
I got them off Etsy. The vendor is WeNeedStinkingBadges. I just looked so I could send you a Link but they donβt have that item listed right now. Maybe they are temporarily out.i like. can i ask where you got it?
They are not. They are about 80% the size of the OEM. I was worried they would look too small on the panel, but I think they look great. I like them better than the OEM ones.Oh I like these too. Are they the same size as the OEM ones?
The dirt is supposed to be outside the Bronco, not inside itAdded a fire extinguisher
Believe me, I have dirt everywhereThe dirt is supposed to be outside the Bronco, not inside it
Those hose clamp mounts were not my cup of tea because of this, and also they take up a decent amount of space. If you don't do heavy duty rock crawlling (where you could potentially puncture a tank and start a fire) the only practical reason to have a fire extinguisher is that it is often required by clubs on group rides. I overpaid for a Warn but it is practical and compact.Might want to apply some weatherstripping under the hose clamps on the roll bar or apply some PPF.
First rateNew bumper!
How did you mount the OEM fog lights?First rate
I got a 3 or 4 inch T bracket from the hardware store, bent the odd leg 90 degrees, bolted to bumper and drilled appropriately spaced holes in straight side of bracket and bolted lights through 2 of their factory holes.How did you mount the OEM fog lights?
Poor photo, homemade bracket is silverHow did you mount the OEM fog lights?