- Thread starter
- Banned
- #1
As mentioned in this thread, https://www.bronco6g.com/forum/thre...t-installed-on-big-bend-bronco-w-o-led.28729/ there's a couple of guys who swapped in sig lights to their Big Bend. I decided to do it also, and I bought two used signature headlights from ebay, one with control module and one without. If you look at the pics, the one in the upper part of the pic is missing the silver control module.
Since RDavis was able to just "plug and play", does that mean the factory control module on the standard Big Bend light will be usable as a control module on the missing one? Or do I need to find the same kind of control module that's on the complete sig headlight (in the lower part of the pic)?
I guess I could take out the factory light and see if the part number on the module matches the one on the sig light, but I might be able to avoid taking out a light just to look at a part number. I want to make sure I'm ready to put these in before I start taking my grill, etc off.
Since RDavis was able to just "plug and play", does that mean the factory control module on the standard Big Bend light will be usable as a control module on the missing one? Or do I need to find the same kind of control module that's on the complete sig headlight (in the lower part of the pic)?
I guess I could take out the factory light and see if the part number on the module matches the one on the sig light, but I might be able to avoid taking out a light just to look at a part number. I want to make sure I'm ready to put these in before I start taking my grill, etc off.
Sponsored