Wow!
how did you get a clean signal out of the OEM system?
how did you get a clean signal out of the OEM system?
Sponsored
It's just a simple Forscan change. He could have also cleaned it up with a DSP assuming he installed a DSP. I would assume he did, but it wasn't photographed.Wow!
how did you get a clean signal out of the OEM system?
I did not tap into the factory connector. There is a factory grommet behind the rubber door jam "filler" trim I used. then went through the factory wire harness door grommet. There is no connector added as these doors will never come off. A deutch connector can added for door removal.Looks sweet!!! How did you wire up these door speakers? Were you able to tap into the factory harness that disconnects when you remove the doors or are they now hardwired and the doors unable to be removed?
Awesome thank you!!!I did not tap into the factory connector. There is a factory grommet behind the rubber door jam "filler" trim I used. then went through the factory wire harness door grommet. There is no connector added as these doors will never come off. A deutch connector can added for door removal.
There is a guy I follow on IG and YT that said he came up with a way to run the wires. I will post a link when he releases the video
I'm curious about this as well. I'd like to know a part number for the pins to go through the factory connectorI did not tap into the factory connector. There is a factory grommet behind the rubber door jam "filler" trim I used. then went through the factory wire harness door grommet. There is no connector added as these doors will never come off. A deutch connector can added for door removal.
There is a guy I follow on IG and YT that said he came up with a way to run the wires. I will post a link when he releases the video
10 TW3's. My first setup was a single 10TW3 on 550watts from a 5Ch Audison. Now I have 2 10TW3's on 1000watts. These are my favorite subsVery nice!!! Having my system put in as we speak. Are you running JL 10's? W-1's or W-3's? They are building me a down-firing JL 10's box behind my 900/5 JL amp.
Amazing. Thank you for sharing!
The 3-way Crossovers are under the drivers seat next to the 4ch amp. The door speakers are activeMaybe I'm silly but where did you mount those crossovers?
I have focal slatefibers and tried to put them in the foot wells but I think I get some sort of harmonic feedback because I'll catch a high pitch whine from the speakers at higher speeds.
Can you elaborate a bit on the parts used in your firewall pass through? Is that piece glued in place?