- Joined
- Feb 16, 2024
- Threads
- 1
- Messages
- 3
- Reaction score
- 3
- Location
- Flowery Branch, GA
- Vehicle(s)
- 2023 Badlands Sasquatch
- Your Bronco Model
- Badlands
- Thread starter
- #1
Just wrapped up the install of RC's High Winch Mount with PRO12000S Winch & Light Bar w/Black Series White DRL. Also used the Parking Sensor and Front Cam Relocation Kits as well as dropped on a Safari Bar w/3-inch Osram Wide Angle Series lights on top(Quad) on my 23' Badlands Sas with factory "Capable" bumper.
Other than relocating the Winch Control to the Drivers side of the Winch Mount and Slight mod to the lower mounting tabs on the Safari Bar with a bit of drilling and all fit up incredibly well. Still have great airflow, ACC sensor is not impeded by the winch mount and all parking assist sensors and front cam work without issue.
Total time to make the mods to the "Capable" bumper and Safari Bar was approx. 2hr. Mounting the Winch and Winch mount took about another 2hr. Wiring everything back to the Upfitter switches and powering the Winch took another 6hr.
Don't let anybody tell you "it" can't be done because you don't have the right bumper.....
Other than relocating the Winch Control to the Drivers side of the Winch Mount and Slight mod to the lower mounting tabs on the Safari Bar with a bit of drilling and all fit up incredibly well. Still have great airflow, ACC sensor is not impeded by the winch mount and all parking assist sensors and front cam work without issue.
Total time to make the mods to the "Capable" bumper and Safari Bar was approx. 2hr. Mounting the Winch and Winch mount took about another 2hr. Wiring everything back to the Upfitter switches and powering the Winch took another 6hr.
Don't let anybody tell you "it" can't be done because you don't have the right bumper.....
Sponsored