B-Pillar Support Brace Bar

[tobyw]

I don't know if this will do anything for adding rigidity, and I'm not really concerned about it, but I was bored so...

Sponsored

 

[Brostango]

That looks great. Might even aid in keeping the sun shade from flapping. Please report back with your results.

 

[zyglyrox]

I’d pay you to make me one. I got tired of waiting for another manufacture to refund my money and work to fix the one I purchased.

 

[wigglysqiggly]

ill second that, will be interested just because

 

[Keerplunk]

I’d pay you to make me one. I got tired of waiting for another manufacture to refund my money and work to fix the one I purchased.

I think I know who the other brace was made by, could you clarify how it did not fit? I was looking into getting one from them and the "Works with Some soft tops" has me questioning that option. I may just spend the extra and get the ford raptor set up.

By the way OP Nicely done!

 

[zyglyrox]

I think I know who the other brace was made by, could you clarify how it did not fit? I was looking into getting one from them and the "Works with Some soft tops" has me questioning that option. I may just spend the extra and get the ford raptor set up.

By the way OP Nicely done!

The one I purchased had curved ends that laid over the sides of the roll bar, which is where the soft top sits when closed. Would only work with the front part open or no top.

 

[Keerplunk]

I just went out and looked at older images of his bar and now understand the issue. Goat Fab has one without the roll over lip that would work. I also looked at the ford option and found it was a few hundred more and had the C pillar section as well. Thanks for the reply. Think I will go with Ford option.

 

[Bryan1995]

I don't know if this will do anything for adding rigidity, and I'm not really concerned about it, but I was bored so...

Are you selling? Can you make me one? because I will buy it. I think the Bronco needed it from beginning. How does it drive right now? Do you get any rattle or movements from the A pillar or B pillar portion, I believe the top portion because it is convertible. It doesn't have the strength and I would like to see what is your experience with this installed on it?

 

[tobyw]

Are you selling? Can you make me one? because I will buy it. I think the Bronco needed it from beginning. How does it drive right now? Do you get any rattle or movements from the A pillar or B pillar portion, I believe the top portion because it is convertible. It doesn't have the strength and I would like to see what is your experience with this installed on it?

Honestly, I can't tell any difference from before... I didn't have any issues with rattles or squeaks other than from my passenger side door window, and I truly just had some time and 2"x0.120" wall tube on my hands so I figured I'd kill a few minutes. With that said, having just run the Rubicon, there was no creaking or groaning from the chassis or body even during times of full articulation and/or embarrassingly hard hits. Is that a result of this spreader? I doubt it, but I don't think it contributes negatively either. It did provide a great place for my fire extinguisher if nothing else...

Sponsored