Recent content by Vellicate

Sorry for the late response, just got home from Drummond Island. I did notch the side of the cover (bottom black piece)

I run the 35x10.5 Kendas. Great tire. Bought them to make sure there was no rubbing. The Sas wheels are .5" wider than mine, definitely recommend sticking with a 12.5 on the Sas wheel. These don't offer a lot of wheel protection on my setup, got 3 of the 4 wheels on rocks already.

I made the bracket myself from some scrap metal I had laying around. Luckily the ugly welds are hidden by the control box. 🤣

The Apex winch will include most everything you should need to relocate . I made my own bracket out of scrap steel I had laying around. My winch came with 3 ft cables to go from the winch to the control box, which were too short for where I needed to go. I was able to find 6 ft 2awg cables...

Best pics I could get.

Homemade bracket, cut and welded out of some scrap I had laying around. I copied the basic design of an ARB compressor mount, made a support to the firewall, upper coilovers bolt and to the passenger fender. It's not the prettiest but it works. I didn't take any pictures of the bracket by...

Very nice setup! Just finished mine up over the weekend, I relocated my control box to the passenger side since I don't plan on running a compressor. I ordered a JCR camera bracket as well, hoping to see that soon.

I run the same setup with Kenda's. I did a Zone leveling kit though. Nice rig!

Got mine yesterday, installed today along with the soft top assist. Didn't notice until I was done with one side but I was sent a set of V1's and V2's, ordered 2 V1's. Boxes are marked V1 on both.. no biggie, wife likes the V2's better. 😂

Fits fine, third brake light is a little tight but usable. May change it out in the future.

Sounds like a possible balancing issue. I would ask them to recheck them. I'm running the same tires on my Badlands and don't have any issues. Had them on for about 6000 miles. I know mine took a good amount of weights to balance.

Only comparison I have. Top picture is stock, bottom is after level. Both are before the 35's were installed.

Can't wait for this and the retro fit steps. Going to be a good month for Chonco. 😂

Got my oil changed today at 7000 miles, emptied the catch can when I got home. In the short time I've had it installed, it's definitely put in some work. Highly recommend for any 2.3L.

Damn.. ordered these through the email you sent me, didn't know there was a coupon code.