Do we know what the center hub size(wheel bore hole size) is? Not a guess, not assuming it is the same as a Ranger...but an actual fact? Someone said the Ranger is 93.1mm But we need the Bronco size confirmed. Thanks
Sponsored
So is there any confirmation on whether the Sasquatch wheels are forged or cast? I’ve read through the thread and have seen just a lot of speculation.
Thanks Zack, I had seen a post that Dicastel was known as a cast manufacture. Plus the trusty B&P does not mention forged:
I haven't seen specs on them anywhere now that you mention it.Is there any info on the optional wheels for the black diamond? I don't see those pictured or listed. I'd consider opting for them if they were wider than the steelies.
I’m assuming that the black ring will be an accessory we can buy? I’m not the biggest fan of the silver and black.Correct. Sas has the silver ring and Wildtrak has a black ring.
It may not be listed as an accessory, but it will be available in the parts department. I plan on replacing mine with black as well (silver looks tacky). Short term, I’ll just plastidip the rings until the parts are available.I’m assuming that the black ring will be an accessory we can buy? I’m not the biggest fan of the silver and black.
https://www.tirerack.com/tires/Spec.jsp?tireMake=BFGoodrich&tireModel=All-Terrain+T/A+KO2Question for the tire experts here... can I run the 285/70r17 (33”) KO2’s on the BD steelies? Not sure if the drop from the 8”-wide BL wheels to 7.5” is a dealbreaker.
not sure why I didn’t think to look for the specs on the specific tire. Thankshttps://www.tirerack.com/tires/Spec.jsp?tireMake=BFGoodrich&tireModel=All-Terrain+T/A+KO2
The 285/70R17 size allows a 7.5" to 9" rim width.
Stig got photos all the wheel sizes and offset numbers for y'all that are on the rims! Hope this helps with tire upgrade plans! Enjoy.
Table added by @North7
Nicely done, thanks!Stig got photos all the wheel sizes and offset numbers for y'all that are on the rims! Hope this helps with tire upgrade plans! Enjoy.
Table added by @North7