Armored up and ready to hit the trails.

[Copperhorse73]

Just finished installing JCR skid plates, Asfir control arm skids and AC Fab sway bar quick disconnects. These skids are super beefy, much less worries about rocks underneath now. Still have to get the transmission skid on but that appears to be the easy part, and breakfast is calling.

Sponsored

 

[TX_Bronco77]

Kind of off topic question but how comfortable is it under the Bronco while working? I quit working on my current car because of it being a pain to get ramps under the front splitter. So I am looking forward to having a truck I can just slide under and get back to wrenching.

 

[Copperhorse73]

Kind of off topic question but how comfortable is it under the Bronco while working? I quit working on my current car because of it being a pain to get ramps under the front splitter. So I am looking forward to having a truck I can just slide under and get back to wrenching.

If u have Sasquatch it’s not bad. I don’t use my creeper because it then becomes too tight but just sliding around on my back on the floor is not too hard

 

[unfortunate]

Just finished installing JCR skid plates, Asfir control arm skids and AC Fab sway bar quick disconnects. These skids are super beefy, much less worries about rocks underneath now. Still have to get the transmission skid on but that appears to be the easy part, and breakfast is calling.

what bumper do you have? Got any pics with the bumper on and the skids?

 

[Copperhorse73]

what bumper do you have? Got any pics with the bumper on and the skids?

It’s just the stock modular bumper with end caps removed

 

[Murph914]

Kind of off topic question but how comfortable is it under the Bronco while working? I quit working on my current car because of it being a pain to get ramps under the front splitter. So I am looking forward to having a truck I can just slide under and get back to wrenching.

Cut up a 2x12 and use them to get a more gentle angle of attack. Had to do that for my first new car - a Contour SVT

 

[TantoIndian]

What kind of sway bar disconnects?

 

[Copperhorse73]

What kind of sway bar disconnects?

https://acfabb.com/products/sasquatch-links-1

 

[TantoIndian]

Love the build man! Looks awesome !!!

 

[Copperhorse73]

Love the build man! Looks awesome !!!

Thanks man, appreciate it. Now that the wheeling stuff is out of the way it’s time to address the sound system.

 

[unfortunate]

It’s just the stock modular bumper with end caps removed

Thanks! I just got the modular bumper to replace my plastic one and was looking at these bash plates as well!

 

[Hamhands]

Nice! I am getting ready to install my quick disconnect on the front, install looks easy but how did it go for you?

 

[Copperhorse73]

Nice! I am getting ready to install my quick disconnect on the front, install looks easy but how did it go for you?

only challenge was tightening the post that holds the pin. Had to find a tool that fit through the pin hole to hold the post while tightening the nut

Sponsored