Bilstein 6100 install question

[Life with Jonesy]

Passenger side still sits higher after couple thousand miles. Looked at front shock to check and make sure things were still torqued. ** when brought home after initial install one shock nut was hand tight. They checked everything out torqued and said let shocks settle. Mistakes happen and very reputable shop.** Anyways this alignment pin pulled right out this evening. None of others are loose. Long story short could this shock be spun the wrong way and why it’s little higher? Why would pin just come out? Something seems off from when installer installed.

Sponsored

 

[dgorsett]

Those pins will come out quite easily so don't worry about that. My drivers side is 3/8" inch high, on my 5100 install, but not noticeable without measurement. Other than that idk.

 

[Life with Jonesy]

Cool. Thank you.

 

[telenerd]

Besides the issue, what clip position did you go with on your 6100? How much lift you get over stock? Thanks

 

[raqball]

Besides the issue, what clip position did you go with on your 6100? How much lift you get over stock? Thanks

I went with clip 5 in the front which gave me 2 1/2" in the front and clip 1 in the rear which gave me 1" in the rear.

I have a winch, winch plate and an ARB dual under the hood that caused additional rake / droop on the front. I am now almost completely level.

Sponsored