- First Name
- Mike
- Joined
- Sep 16, 2020
- Threads
- 6
- Messages
- 748
- Reaction score
- 1,394
- Location
- Washington
- Vehicle(s)
- 2014 KTM 1290R
- Your Bronco Model
- Undecided
I've heard about them and have a co-worker that swears by them, but I would approach their claims about adhesion with caution, since most automotive epoxy primers have decent adhesion to stuff like chrome/glass. (my experience is with the PPG DP- epoxy primers and having to turn a chrome bumper into a painted one)Not trying to sound like an abrasive guy, but It has been discussed in probably a dozen threads already.
The older version of the MIC top I saw in person had a lot of texture to it. Identical to the grain and texture in a lot of aftermarket speaker pod Harley parts I have painted in the past.
I did everything textbook perfect with adhesion promoter, scotchbrite (sanding will reduce the texture in an uneven manner unless you sand ALL the texture off and featherfill prime, block sand it), etc. Some adhered just fine and looked good, some failed.
The newer version no one has seen in person yet other than the people on here who actually work at the factory.
The grain looks considerably less.
At the end of the day, everything can be painted, in theory.
I have begun using Tamco products, and they swear they have a primer that will adhere to anything, even chrome.
Until I try it myself I can't attest to that or defend it.
IF that is the case, in theory you should be able to scotch the whole thing, apply this primer (with some adhesion promoter to be safe), sand, and paint and be just fine.
I have done many Jeep tops in my day, both in paint and bedlining.
No failures, but their top in a considerably smoother surface (and what appears to be a different plastic) than what i saw in October at the TN show.
I can say 100% dipping it, plasti-dip, and wrapping are not going to end well just due to the grain. Your two solutions are really a urethane-based quality bedline material or paint based on the above assumptions.
Outside of that, I'm really hesitant to suggest painting or bedliner spraying the MiC top because of it's composition and unknown adhesion, even with adhesion promoters and proper prep.
If someone was really serious about it, and with the current version's finer/smaller texture, I would strongly recommend using a Dip Your Car dip kit.
It's not exactly cheap, but it could be a decent alternative and wouldn't ruin the top, if things didn't go well, and it can be removed.
Matte white medium Dip Kit with gun.
(I did medium kit with the 4-door in mind and to possibly have some left over in case of an 'oops' occurring)
I wish I had experience with this stuff, but sadly, I don't.
Sponsored