- Thread starter
- #1
Hey All,
im new here. I’ve been reading a lot around stereo installation. I’m picking up a 22 Wildtrak with B&O today.
Instead of using the Plug and Play kit, has anyone used the LC7i post amplifier?
What I would like to do,
Replace 4” dash speakers with JL C1
Replace 6.5” kicks with JL C1 full range
Split front signal into amp and power each set run full range to both sets of front speakers using the summing capability of the LC7i.
Replace rear pods and run JL C1 6.75 and power of rear speaker.
Then add subwoofer, tbd, and power off sub output.
Thoughts? Also I’m not set on the JL C1’s just a thought at this point.
im new here. I’ve been reading a lot around stereo installation. I’m picking up a 22 Wildtrak with B&O today.
Instead of using the Plug and Play kit, has anyone used the LC7i post amplifier?
What I would like to do,
Replace 4” dash speakers with JL C1
Replace 6.5” kicks with JL C1 full range
Split front signal into amp and power each set run full range to both sets of front speakers using the summing capability of the LC7i.
Replace rear pods and run JL C1 6.75 and power of rear speaker.
Then add subwoofer, tbd, and power off sub output.
Thoughts? Also I’m not set on the JL C1’s just a thought at this point.
Sponsored
