- First Name
- Ezra
- Joined
- Mar 6, 2021
- Threads
- 9
- Messages
- 125
- Reaction score
- 771
- Location
- Columbus, Ohio
- Vehicle(s)
- 2021 White Ford Bronco (moar door, 7spd, lux)
- Your Bronco Model
- Badlands
- Thread starter
- #1
Since I ordered a 4-door OJWhite Badlands, I learned from this forum that my rig would have no rear area cupholders. However, once I discovered the front seats have a Molle panel on the back, I have engineered my own cupholder solution!
I found a Molle cupholder online that fits the Bronco Molle panel, and I measured the functional cupholder in my Toyota (3.25 in diameter, 3.25 in depth) and purchased aPVC segment from Home Depot to sit in the Molle piece (to support drive thru cups besides water bottles).
Iāll probably spray paint the PVC in either Antimatter Blue or Cyber Orange to match the Badlands stitching. The Molle pieces cost about $15 each, and the PVC was $1.65 each. As I wonāt be able to test this until after I get my Bronc, please stay tuned for my field test results...
...anything to pass the time, #amirite? Next Bronco project: crocheted Bronco throw pillows in Cactus Gray
I found a Molle cupholder online that fits the Bronco Molle panel, and I measured the functional cupholder in my Toyota (3.25 in diameter, 3.25 in depth) and purchased aPVC segment from Home Depot to sit in the Molle piece (to support drive thru cups besides water bottles).
...anything to pass the time, #amirite? Next Bronco project: crocheted Bronco throw pillows in Cactus Gray
Sponsored