Search results

Last year Flip posted a shop manual picture of the rear window schmatics. This showed that the bolts must be discarded and not re-used.. I can not now find that. Can one of you help and old man? @flip, is it possible to re-post this info?

heeeeyy I'm all shook up

My brake pedal has a rattle/thunking sound when driving on rough roads. The area of noise seems to be the brake pedal within the yoke that comes out of the floor (in a rubber boot) and this yoke has a bolt that runs through it. I can use my hand and shake the pedal side to side a little and...

What GMRS frequency do you use? I am interested in learning what GMRS frequencies are being used the most and also in what areas. I know CH 16 is used for general 4X4 offroad. But, for instance in MOAB is there a frequency that locals use the most? In Death Valley is there a preferred...

When going into flat tow with 2.7 and auto transmission when do you put Air Conditioner into re-circulate so that it stays there during flat towing? We put it into Re-Circulate right after putting Bronco into Accessory Mode. Is this the right step?

Our Bronco has always started but regularly goes into battery saver mode. I have been keeping an eye on the battery voltage and it seems low. The battery has never failed to start the Bronco. It just seems to not keep a full charge. The factory battery has been charged with a latest model...

The last couple of times we turn off the Bronco we get this on screen. Mid package with push button start stop. Any ideas what it means? Or Why it shows up?

There are a number of rear shock skids available. It looks to my untrained eyes that these just move the point of impact forward and do not provide any "skid" ability. Is there a brand that would help the Bronco ski or skid over a rock ledge instead of just bash it? Looks that it could still...

The section in Owners Manual that explains Asscessory Switches mentions Delay Accessory being turned on. This is supposed to turn on the ability to use an Accessory Switch with the ignition being turned off. I have search the Owners Manual and this forum and can not figure out how to turn on...

I've long wanted to drive to top of Bristol head near Creede, Colorado. I have found UTV videos but nothing about 4x4 such as Bronco. Is the road suitable in width for a Bronco?

Factory tires run 39 psi. We run 30 psi and one tire is showing a warning. Can the tire warning pressure be reset to a different lower pressure without FORscan?

How are the air pressure flaps in the tailgate removed? Without damaging them? Say perhaps if a person dropped a bolt inside tailgate and needs to retrieve it.

looking at kinetic recovery ropes and my eyes are beginning to cross. Is a 7/8 inch rope rated at 28,000 pounds breaking point enough for a Bronco? There are a few brands that claim Made in USA. What are some trusted brands?

Do you know the size of wire or the amp rating of the rear cargo right hand side 12 volt power port....I would call it a cigerette lighter. The Bronco Equipment Installation Guide shows the right hand Quarter panel wire to be 1.5 mm non powered white and orange wire ( that is approx 15...

I have been using the Comet 2x4SR dual band for many years. Comet designed it for 2 meters thru GMRS. Comet says it needs a ground plane which is fine for most vehicles. I'm a Little confused as the antenna is 40 inches long and a 1/2 wave 2 meter should be 39 inchs. Anyway, I am trying to...

I want to make a change on my tire carrier need a bolt that is a little longer. The factory bolt looks like the pic below. It is a M8. The bolts I find locally look just like a standard hex head bolt NOT like the one in the picture. If I get a M8 size and the grade (5.8, 8.8, 10.9) is correct...

I would like to remove one of my front rooftop accessories panels and do not want to damage it. Do the front rooftop accessory panels simply pull off? Does it matter top or bottom first?

Found some! I want to buy all 8 crash bar bolts.

We just discovered the San Juan Connection. They list repeaters in Lake City, Silverton Engineer Pass and Buffalo Boy area, and a few other locations in the area. Is there much of the Alpine Loop that is not covered by 2M or 70cm? Also, those that use GMRS. Is this area covered very well by the...

Moved to Want to Buy