Amazon Mud Flaps, for the money they are amazing.

[Jeffola]

So I bought these with the same thoughts as I usually have when I shop Amazon, I can just send them back.

Item https://a.co/d/gllIt6s

The instructions aren't awesome, and some parts were mis-marked. Great design, sturdy and good looking.

Fronts took longer to install due to the Crash Bar bolts being REALLY F-ING tight. Again, the design is brilliant, all the hardware is black, if the brackets rust, I'll clean and krylon them.

Sponsored

 

[Fly by Nite]

I used them too. It was a different seller, WonVon. They were under $60 at the time. Now at under $50, they're an even better value.
They're also sold by Octomo, DKMGHT, and Moslogy.
Here's a thread on them:
https://www.bronco6g.com/forum/thre...n-for-mud-flaps-to-quick-release.63211/page-2
I had to trim off the 'square' that goes around the front crash bar to fit my Squatch tires.

I ended up replacing the flaps with the Plasticolor flaps for a little more coverage and a cleaner look. But I did keep some of the hardware from the ones you got.

 

[adamargyle]

Has anyone tried trimming these for a Sasquatch package? For the price it seems like a good deal and not too much work to trim

 

[Doc TOC]

They do like nice. But they don't seem to work!?!

 

[Jeffola]

They do like nice. But they don't seem to work!?!

I had not washed the Bronco in a few months. Finally today I was able to.

 

[Fly by Nite]

Has anyone tried trimming these for a Sasquatch package? For the price it seems like a good deal and not too much work to trim

Yes. The rears fit fine. The fronts may need this square trimmed back about 1/2". You will need to buy bolts to attach the brackets to the crash bar stubs.... either long metric bolts to use the factory nutserts, or just use some short 7/16" bolts to attach brackets to one wall of the crash bar stub.

Sponsored