Blackout Kit for Bronco Sasquatch now on Ford Performance Parts Site

[howardde]

Wow really? I went with a shop here in Denver on recommendation from a friend and they charged $300 for all five rings. Based on what I saw on here around that time it seemed to be on the expensive side at the time, but they offered to retouch them if I dinged/scratched them off-road.

Cheapest quote I got in the greater NYC area was $500 so I also went ahead and just bought new black rings (aftermarket, not OEM) for $350.

Sponsored

 

[howardde]

Does anyone have the part number for the black lug nuts from Ford? I figure I need to get them since I've gone this far. Also, has anyone blacked out the Bronco emblem in the middle of the wheel?

 

[Ft. Worth Rob]

I’ll stick with my powder coated rings at $125. For $900 they’re not even giving you the $18/each screws that hold the rings onto the wheels?

 

[NVCowboy]

Yes!!! . . . $900 . . . Noooo!!

I really think a rattle can hammer tone would add interest and easy repair for less.

I also have sooo many more accessories that are way more important. Rear bumpers and swing out tire carriers will make ya sweat a little.

 

[howardde]

It's not though. But it should be. There is no reason why the black lugs weren't standard on a Wildtrak. I bought just the lugs because I couldn't stand the silver ones.

Hi, where did you get the Black Lug Nuts? Is there a part #? Thanks

 

[howardde]

I have black 1 piece lug nuts and blacked out center caps. Just waiting for the Wildtrak to arrive.

Where did you get your black 1 piece lug nuts and blacked out center caps? Many thanks

 

[howardde]

I bought the RTR Tech 6 wheels in black on sale last year for $1000, a black emblem for like & $20, and black Lug nuts for like $50. Why is this $900??? I got 5 entire wheels for only a little more.

[/QUOTE]

Hi - where did you get your Black Lug Nuts? Thanks

 

[El Bronco Blanco]

Hi, where did you get the Black Lug Nuts? Is there a part #? Thanks

from my local dealer. Used some pass points. They’re much more expensive than need be, but I wanted Ford ones. Didn’t like the look of most aftermarket ones, but didn’t go down a rabbit hole searching either.

Ordered a non-marring 19mm socket online to install them as they are just coated black.

CASOMAN 1/2-Inch Drive Wheel Protector Impact Socket-19mm, Thin Wall Deep Impact Socket, 6-Point, Non-Marring, Color-Coded, Laser-Etched, Metric, CR-MO https://a.co/d/6IqaoKD

Also Ford doesn’t even sell black locking lugs, so i grabbed these.

McGard 24526 Cone Seat Wheel Locks Black (M12 x 1.5 Thread Size) - Set of 5 https://a.co/d/5yqla6v

Sponsored