- Thread starter
- #1
It would be nice if a manufacturer made a front receiver hitch like this for the Bronco. https://www.draw-tite.com/product/65022_front-mount-receiver
Sponsored
Correct. Approach angle, front/rear winching, & multiple other uses as well. The link I provided looks like a no brainer for the Bronco.I'd like one of those as well. That way you only need to put a winch on when you're going wheelin'.
I was crossing my fingers someone would integrate this into a bumper. No dice so far. I'll probably have to do it myself, just like the sliders.I'd like one of those as well. That way you only need to put a winch on when you're going wheelin'.
The Bronco is a perfect candidate for the receiver hitch located inside the bumper. Just have the ACC relocate kit or remove the false piece for lower trims and done. Praying someone comes up with something soon or I might have something fabbed up myself.I was crossing my fingers someone would integrate this into a bumper. No dice so far. I'll probably have to do it myself, just like the sliders.
Gives me an excuse to buy a tube bender.
Awesome! I have seen this before. Great job!I know that I have shown this before, its my own creation (and I think there is another one on B6G that has been shared as well)
You could have something like this built WITHOUT the winch mount.. The receiver is is sunk into the frame horn and I have two for attaching a snatch block etc.