- Thread starter
- #16
This are my amp settings, I lowered the sub gain a bit.That amp has serious power, I have the DSP version. Have you done any tuning of the amp other than maxing out the gains? With as much power as it has for the sub channel (and all the channels), you shouldn't need to have the gain way up. Are you using the channel summing to make sure you get a full signal to the sub? Can you post a picture of your amp settings?
Do you know how the PNP has the front speakers connected? You have (2) 4 ohm speakers on each channel, so I am guessing it is setup in parallel with an overall resistance of 2 ohms. Your rear channels are 4 ohm speakers. It might not like that as it is effectively a 4 channel + 1 channel amp.
Sponsored