High clearance cross member for the 2.7?

[‘21OBX]

Has anyone heard of a high clearance cross member/K member for the 2.7?
Went wheeling this past weekend and they rubbed all over. Barely hit a skid plate because it hangs down so low it hung up on everything. I’d like to find or make a setup that is even or slightly higher than the frame to get the 2” of clearance back.

Sponsored

 

[Cybindustries1904]

Not that I have found yet I am having the same issue. Mine are beaten to hell. Ill have to fab something up soon.

 

[Dream_Solventless]

I think I remember reading something about fun-haver having something in the works that replaced the crossmember and integrated a skid, but I can’t find it now

 

[‘21OBX]

Not that I have found yet I am having the same issue. Mine are beaten to hell. Ill have to fab something up soon.

I was just under the Bronco. Looks like if someone could make a part to slide in the crash bar mount then drop down from there and extend to the cross member. My skid plates barely got touched. But those are beat to snot. I’m lifted 3.5” on 37’s. If I had a shop and some time I’d make my own. The stamped steel used by ford can’t be hard to match in strength for those two pieces.

Sponsored