Hi,Before I went any further, I thought I better test to make sure all the lights worked. All good!!
They are on there pretty good. I’m sure they can be removed, but you would have to remove the adhesive and reapply new. As far as the original letters, they have or had plastic nubs that went through holes on the grill and were melted (stamped) to the inside of the grill. That’s why it was easiest to just take a drill bit to the plastic and they came right off. I don’t know how you could take them off and reapply them. Maybe short screws or get a plastic repair kit to add plastic and remelt? Not sure on that.
These look great. Thinking of leaving these on all the time, is the amber backlight visible at all in daylight? Appears they are turned off in all of the daylight photos I have found so far. I have a Black diamond with factory white letters and Oxford white paint, debating if I should get white letters with Amber or stick with the black?They are white underneath. Here are a few photos
The ambers look so good!!Just got these deliveredInstalling now. I’ll post photos once finished.
Finished. A few conference calls in between the install, but pretty easy. Maybe 1-2 hours. Connected them to the aux switch wire in the front under the hood, but will probably end up just going to the parking lights. Overall… very pleased! I think they are at the perfect level of brightness. Not too bright like everyone says about the white.
If you are careful when you remove the stock letters and not drill out more than you need to, they can be reapplied to another grille with some JB Weld Plastic Adhesive, I have done this.
