- Thread starter
- #1
Does anyone know how long the rear 12 volt port stays on after the engine has been turned off?
Sponsored
https://www.bronco6g.com/forum/threads/12v-in-cargo-area-always-on.17034/
I posted this a while ago - I think it stays on for some time after the vehicle is off, but can't be bothered to read through the entire thread again lol. And I don't have my Bronco yet, sorry.
"we found that the 12V power source in the rear of the Bronco will stay powered after vehicle shut off for 1 hour, and the factory rear light will stay on for 10 minutes."Does anyone know how long the rear 12 volt port stays on after the engine has been turned off?
The presenter in this video talks about it at the 10:20 point."we found that the 12V power source in the rear of the Bronco will stay powered after vehicle shut off for 1 hour, and the factory rear light will stay on for 10 minutes."
source:
"we found that the 12V power source in the rear of the Bronco will stay powered after vehicle shut off for 1 hour, and the factory rear light will stay on for 10 minutes."
source:
And do we know the Bronco will be smart about it, and turn it off if the battery gets too low? Or will it leave it on for 18 hours even if it kills the battery?There is an option in FORScan to update PowerPoint to a maximum of 18 hours.
However it is unknown if this setting has any affect on the cargo area 12v outlet.
I'd prefer it to always be live, but 18 hours would be great, thanks. If anyone has a link to how to do this, please advise.There is an option in FORScan to update PowerPoint to a maximum of 18 hours.
However it is unknown if this setting has any affect on the cargo area 12v outlet.
Using Forscan, change PowerPoint from enabled to disabled. Then it will stay hot.I'd prefer it to always be live, but 18 hours would be great, thanks. If anyone has a link to how to do this, please advise.
How exactly sid you do that? Iām trying to do it but I only see the option to change the timeUsing Forscan, change PowerPoint from enabled to disabled. Then it will stay hot.
There are 2 options to select in Forscan regarding timeout. Above the one for the actual time, you can enable/disable.How exactly sid you do that? Iām trying to do it but I only see the option to change the time