- Thread starter
- #1
I wanted to show a few pics of my recent mudflap mod. It was pretty easy. I templated the fender flare with a pencil and paper, held up the flap to the oem hole locations, marked an endpoint at the fender and an endpoint at the bottom. I then put my hand drawn template on the beginning and ending point and traced a line to cut. Forget dremels and just use a good pair of snips or heavy scissors. Use a dremel to smooth out the line if needed. I took the cut off parts and used two small screws to create an L bracket (a mod from a previous poster). 2 of the u brackets were used to fasten to the fender. I used the factory fastener locations and added an additional push pin and a leftover c clip to attach to the fabric liner.
Sponsored