- Thread starter
- #1
I installed the Whipple Megacooler today and ran into an issue. I wanted to see if anyone else ran into this problem.
There is a step which requires installing the plastic shutters from the back of the intercooler onto the new intercooler. I ran into a problem at this point. On one side of the intercooler, the welded on brackets appeared to be in the wrong place, about an inch lower than the factory plastic piece.
I proceeded with the install without the shutters, and have an email into Whipple, but wanted to check the forums to see if anyone else experienced this.
There is a step which requires installing the plastic shutters from the back of the intercooler onto the new intercooler. I ran into a problem at this point. On one side of the intercooler, the welded on brackets appeared to be in the wrong place, about an inch lower than the factory plastic piece.
I proceeded with the install without the shutters, and have an email into Whipple, but wanted to check the forums to see if anyone else experienced this.
Sponsored