Windshield molding is not touching the windshield.

[SZairborne]

The bottom center portion of my windshield does not touch the plastic molding. The sides touch, but the closer you get to the centerline of the vehicle the bigger the gap. Its about 1/4 in if not more. Anyone else have this problem? I attached a photo for reference.

Thanks

Sponsored

 

[Grumpy]

Have you tried pressing down on the trim? It should just press in place. When I installed my ditch lights, I had to pull up on that trimmed piece on both sides to accommodate my light harnesses. Once I had the harness fed through, I just pushed in and down on the trim and it went back in place.

 

[SZairborne]

Have you tried pressing down on the trim? It should just press in place. When I installed my ditch lights, I had to pull up on that trimmed piece on both sides to accommodate my light harnesses. Once I had the harness fed through, I just pushed in and down on the trim and it went back in place.

Ill give that a try.

 

[Grumpy]

You should be able to push in toward windshield and then down.

Sponsored