- First Name
- Adam
- Joined
- Aug 30, 2021
- Threads
- 355
- Messages
- 4,395
- Reaction score
- 5,858
- Location
- Lindenhurst, NY
- Website
- www.4x4TruckLEDs.com
- Vehicle(s)
- 2018 Raptor & 2021 Bronco Outer Banks
- Your Bronco Model
- Outer Banks
- Thread starter
- #1
We received our Baja Designs XL Linkable Kit for the bumper today and wasted no time putting it on (well okay I had to wait till I got home, as I was way too busy again today, since we got some Baja Designs Fog Kits in stock we were busy shipping back-orders out)
This kit includes everything you need, outside of some common hand tools
A tip for you during installation if you get this kit... get yourself a 1/4 ratcheting wrench and a hex bit set with a 1/4 shank. When you loosen the center lights up for installation, it's going to be difficult to re-tighten them with the provided allen key. If you use a tiny next bit (one that normally goes in the end of a screw driver) and a ratcheting wrench (not 100% necessary a 1/4 wrench will do) you can make life a lot easier.
This kit is available here and as always, PM me for pricing
https://www.4x4truckleds.com/vehicle-specific/ford-bronco/2021-bronco/
This kit includes everything you need, outside of some common hand tools
A tip for you during installation if you get this kit... get yourself a 1/4 ratcheting wrench and a hex bit set with a 1/4 shank. When you loosen the center lights up for installation, it's going to be difficult to re-tighten them with the provided allen key. If you use a tiny next bit (one that normally goes in the end of a screw driver) and a ratcheting wrench (not 100% necessary a 1/4 wrench will do) you can make life a lot easier.
This kit is available here and as always, PM me for pricing
https://www.4x4truckleds.com/vehicle-specific/ford-bronco/2021-bronco/
Sponsored