3M PPF film added to lower doors for extra protection - DIY

[los7883]

I call that sudden expertisim....
Love it. Good job

Thanks. So far so good. Hasn’t peeled up yet. Figure it should be cured in another day.

Sponsored

 

[los7883]

It’s OKaay but it looks like you need a little more practice…… Where are you at? I’ll go over there and you can do mine. By that time you’ll be a professional!
jkjk great job looks good!

Lol thanks. Feel a lot more confident now. Just installed the windshield film. Still fighting with the fingers though.

 

[BuckYeah]

Nicely done, sir! This is one of the first modifications I'm going to make to my Bronco once it arrives. It's a smart way to avoid stone/debris damage on your flanks.

 

[bsailers]

Sasquatch, Rockslide Steps and your done.

 

[KompressorV12]

PPF and other wraps are actually a LOT easier than they look. Assuming you have precut pieces all you need is a soapy solution in spray bottle and squeegee and you can move the film around to your hearts desire. Just go from the middle out for air bubbles. A little heat and bam. Flat surfaces are so easy a kid could do it and the bronco is as flat as they come.

 

[SROC3]

nice man!!! - you got links for the film and "equipment" you used for the install on amazon? I'm going to try this!!!

 

[Sassy51]

Lol thanks. Feel a lot more confident now. Just installed the windshield film. Still fighting with the fingers though.

I KNOW i couldn’t do this so hats off to ya sir! I’ll be shopping around not sure ceramic or ppf…. prolly ceramic

 

[2DR22Bronco]

Thanks for the share! Good Stuff!

 

[Ogre]

Kudos! Pro tip and good job!!

 

[coachoates]

I KNOW i couldn’t do this so hats off to ya sir! I’ll be shopping around not sure ceramic or ppf…. prolly ceramic

SunTek makes a PPF that is combined with ceramic…warranty for 12 years.

 

[DieselF16]

Nice job, and good idea with the tracing. Definitely wanting to protect my paint AND the normal interior abrasion spots (rear cargo area, lower door where foot could abrade, threshhold/door sills. )

 

[KNXBronco]

Excellent job! Thanks for posting.

 

[broadicustomworks]

I applied the XPel Armor Vinyl to mine I’d guess about 12 months or so back.
It has definitely done its job.
One single rock penetrated it in one spot, all others have bounced off.
Touched it up with a Sharpie.

I do have a few spots above where it stops now, but unless I went up to the door handles with it…

Bought directly from their site.

 

[los7883]

Nicely done, sir! This is one of the first modifications I'm going to make to my Bronco once it arrives. It's a smart way to avoid stone/debris damage on your flanks.

Yup same here!

 

[los7883]

PPF and other wraps are actually a LOT easier than they look. Assuming you have precut pieces all you need is a soapy solution in spray bottle and squeegee and you can move the film around to your hearts desire. Just go from the middle out for air bubbles. A little heat and bam. Flat surfaces are so easy a kid could do it and the bronco is as flat as they come.

Yea i’m no expert but after doing these i feel a lot more confident if I had to do something else on it.

Sponsored