- First Name
- Jonathan
- Joined
- Dec 7, 2021
- Threads
- 8
- Messages
- 373
- Reaction score
- 508
- Location
- Tucson, AZ
- Vehicle(s)
- FJ Cruiser [sold]
- Your Bronco Model
- Badlands
- Thread starter
- #1
It came yesterday so today was like an ad infinitum of wiring. Install of the unit was relatively easy but I had to remove our Tuffy lock box and our tailgate table to do the wiring in addition to all the other little panels. Also, the ARB compressor I got on eBay looks like it had a tiny bit of usage but we didn't pay full price--just nearly full price.
I have to say the AGS install instructions (a video) were great and always explained tool sizes for every step. Burnt through my phone battery having to keep bringing it up but not sure written instructions would've been as good even though I usually prefer that.
All parts seemed duly constructed. The only one that scared me was the cord passthrough gland. Just barely had enough thread to grab on the inside. I cleaned up my hole pretty good (eww) to be sure it wasn't some trash around the edge.
My annoying mistake was, although I was trying to be very careful to not have to depin the connectors by prerunning the wires, when I was done, somehow I had passed the large wire harness through the passthrough but I had not passed the small (purple wire) harness through so I had to depin that connector (only two pins thankfully but shame).
Product:
https://agsoffroad.com/products/2021-bronco-air-gate-kit
QUESTION: Can anyone tell me how to make this the banner image at the top of the post?
Install in pictures:
I have to say the AGS install instructions (a video) were great and always explained tool sizes for every step. Burnt through my phone battery having to keep bringing it up but not sure written instructions would've been as good even though I usually prefer that.
All parts seemed duly constructed. The only one that scared me was the cord passthrough gland. Just barely had enough thread to grab on the inside. I cleaned up my hole pretty good (eww) to be sure it wasn't some trash around the edge.
My annoying mistake was, although I was trying to be very careful to not have to depin the connectors by prerunning the wires, when I was done, somehow I had passed the large wire harness through the passthrough but I had not passed the small (purple wire) harness through so I had to depin that connector (only two pins thankfully but shame).
Product:
https://agsoffroad.com/products/2021-bronco-air-gate-kit
QUESTION: Can anyone tell me how to make this the banner image at the top of the post?
Install in pictures:
Sponsored
Last edited: