That is a great solution. What NMO mount did you use?If you remove the bolts holding the tie down points down, the rubber flooring can be pulled up easily. I ran the coax under that along the side to the rear seats. I then ran it in between the single seat and double to the floor. I was lazy and just ran it on the floor under the mat. I figure you'd never know it's there. I would have used the door trim but 17' wasn't long enough to take that route.
From there I ran it under this piece of the center console.
I backed out the bolt located below to run the cord up above it. It also keeps the coax from coming down.
All done!
Sponsored