Dash accessories mounting point thread size?

[604Bronco]

I’m guessing this will work? Just wanted to confirm before I purchase it.

Thanks!

https://joby.com/ca-en/griptight-pro-2-gorillapod-jb01551-bww/

Sponsored

 

[UtahBrandon]

One of these, if it's not too tall or too close to the windshield would be ideal. I use it for my kid's soccer games and it's pretty amazing how well it steadies the shot.
https://www.dji.com/om-4

 

[Jb7]

This is the one I picked up, pretty durn sturdy, can hold Phone vertical but looks
Better horizontal and doesn’t affect visibility as much as vertical does

 

[Wmneill]

One of these, if it's not too tall or too close to the windshield would be ideal. I use it for my kid's soccer games and it's pretty amazing how well it steadies the shot.
https://www.dji.com/om-4

I have the 3 it would take great shots but I think it might be a bit tall there on the dash , plus would still need a double ended threaded screw One for dash other for the dji

 

[Jb7]

Here are the two screws I used, one on left is a Allen set screw that I used till I bought the one on the right from Amazon, both were super cheap

 

[Wmneill]

Here are the two screws I used, one on left is a Allen set screw that I used till I bought the one on the right from Amazon, both were super cheap

yeah that should work

 

[604Bronco]

This is the one I picked up, pretty durn sturdy, can hold Phone vertical but looks
Better horizontal and doesn’t affect visibility as much as vertical does

Have you (or anyone else) purchased this and mounted it in your Bronco yet?

I picked one of these up but I don’t really understand how it’ll properly mount without being too close to the dash.

Any pictures would be helpful/appreciated! Thank you.

 

[604Bronco]

Have you (or anyone else) purchased this and mounted it in your Bronco yet?

I picked one of these up but I don’t really understand how it’ll properly mount without being too close to the dash.

Any pictures would be helpful/appreciated! Thank you.

Or do I also need this piece too?

 

[Jb7]

Or do I also need this piece too?

I had some rubber washers and used one with a 1/4” hole as a spacer to bring the ht up right above dash, the bottom
Of the phone holder is stationary, the top moves up and Down or side to side depending how you have it oriented

 

[604Bronco]

I had some rubber washers and used one with a 1/4” hole as a spacer to bring the ht up right above dash, the bottom
Of the phone holder is stationary, the top moves up and Down or side to side depending how you have it oriented

Thanks - do you happen to have a picture of yours installed?

Sponsored