- Thread starter
- #1
Drove our Black Diamond Sasquatch on the freeway for approximately 130 miles stopped at our destination for an hour or so. Got back in and started to drive within a mile I went around a 130 degree turn at low speed less than 5mph. About halfway thru the turn the steering wheel jerked and there was a loud metallic clunk front the front end, at the same time the Bronco acted like I was driving with a locker engaged. Sound and jerky nature was very reminiscent of driving with a lunchbox locker and turning under power. My wife said what the hell is that, I have her the shoulder shrug and obligatory no F’n clue. Quick visual inspection revealed nothing. CV’s were intact, drive shaft intact. Did several more slow speed turns and could not replicate. Drove the 130 miles back home and got underneath again. Only thing of notice the the front pinion seal is leaking. Not enough to leave a puddle in the garage but enough to see it running down the housing. Have only engaged the front and rear locker once and that was over 1000 miles ago this was also the last time it was in 4WD. I did put it into 4Hi 4lo and try both lockers last night. Everything seems to be working. It’s going into Kendall Ford in Eugene OR tomorrow for the leaking seal and inspection for the clunking. Will update.
Sponsored