roof hold down levers....
Sponsored
roof hold down levers....
The one I downloaded from extrapolating and then converting to JPG to input into marzipano; it didn't work. How did you do it?The image you linked? or the one i linked?
The one you found is not a 360 pano image
you need the 3d version.The one I downloaded from extrapolating and then converting to JPG to input into marzipano; it didn't work. How did you do it?
I may be close..Start with the url for the image of the bronco in the email. Extrapolate from there.
Here's a clue....
Just take a look at the html source of your reservation email!
Ok now I'm confused, the pic looks similar to the one in your OP. Is your reservation a First edition? Because my interior is showing with the same colors as your OP.you need the 3d version.
Its as east as 1 2 3/vehicle.png
Here's a clue....
Just take a look at the html source of your reservation email!
It has to be the one with the "warped" image, There are more than one image for EXT and INT, its third oneOk now I'm confused, the pic looks similar to the one in your OP. Is your reservation a First edition? Because my interior is showing with the same colors as your OP.
This one shows my 2 door First edition. Looks to be the same seat color as the one in your OP.It has to be the one with the "warped" image, There are more than one image for EXT and INT, its third one
? it looks correct other than being in the wrong spot; you can see the rear of the frame.FYI i am not claiming that these are super accurate in any way, i just found them interesting.
And i think there is a reason the build site isn't up
HELLO BUMPER
http://build.ford.com/dig/Ford/Bronco/2021/HD-TILE/Config[|Ford|Bronco|2021|1|1.|353A.E5D..M7...RET.]/EXT/3/vehicle.png