Mudflaps install hack (without removing crash bar)

[DaveInSA]

Behold! The rear crash bar from the front wheel well of a 21 badlands 2 door, and one of it's bolts.

Just for reference

Sponsored

 

[805BaseSquatch]

Has anyone done something like this on the Sasquatch package? Without the crash bar.

@BudgetBronco any ideas?

 

[BudgetBronco]

Has anyone done something like this on the Sasquatch package? Without the crash bar.

@BudgetBronco any ideas?

@dcg2 came up with a solution for this, here is his post: https://www.bronco6g.com/forum/threads/diy-sasquatch-mud-flaps.41689/

 

[Julz670]

I cleaned the tar off the side of my Bronco and I did this today with the same flaps, black hose clamps, and a screw with a spacer up top. Works great!

If i were to do it over again I would use the 9" flaps from Plasticolor, i think the 11" flaps are too long for non sas but i just slid them up a little higher and they fit fine

 

[jimwalston]

I cleaned the tar off the side of my Bronco and I did this today with the same flaps, black hose clamps, and a screw with a spacer up top. Works great!

If i were to do it over again I would use the 9" flaps from Plasticolor, i think the 11" flaps are too long for non sas but i just slid them up a little higher and they fit fine

Please post picture of the screw/spacer and the cut outs on the flap. I'm going to make these before I pickup my Bronco. I'm going to install them before I drive off the lot hopefully next month.
Link to black stainless hose clamps that I purchased
https://www.amazon.com/dp/B09VGZPF6W?ref=ppx_yo2ov_dt_b_product_details&th=1

 

[Julz670]

Please post picture of the screw/spacer and the cut outs on the flap. I'm going to make these before I pickup my Bronco. I'm going to install them before I drive off the lot hopefully next month.
Link to black stainless hose clamps that I purchased
https://www.amazon.com/dp/B09VGZPF6W?ref=ppx_yo2ov_dt_b_product_details&th=1

I bought those same clamps, second to largest one worked perfect, just need to trim off a couple inches after you tighten it.

Screw I used was probably 1.5" with a 1" spacer behind the flap.

Sponsored