- Thread starter
- #1
Wanting to mount some pod lights for chase lights off my Trailrax, was wondering if anyone had done this already and could show me how you wired it. Would like to an AUX switch.
Sponsored
Yes another member did it. Search the forum and you'll find it. Good luck I love the look of TrailRax!Wanting to mount some pod lights for chase lights off my Trailrax, was wondering if anyone had done this already and could show me how you wired it. Would like to an AUX switch.
Great, hoping I can find it.Yes another member did it. Search the forum and you'll find it. Good luck I love the look of TrailRax!
Good luck.Great, hoping I can find it.
I want to do the same. Did you ever figure out how to do this? Thinking of two BajaDedigns S1 or S2 but trying to figure the best/easiest way to wire them. Thanks.Wanting to mount some pod lights for chase lights off my Trailrax, was wondering if anyone had done this already and could show me how you wired it. Would like to an AUX switch.
Oh I can help!Just got my Heretic BA-2s and reached out to them to see how'd they recommend install with the included 2 light harness using the rearward power circuit to the factory up-fitter switches.
maybe @fronc can give some more details before I get an email response.
Caught me!Yes another member did it. Search the forum and you'll find it. Good luck I love the look of TrailRax!
Any chance you have a photo of where your wiring goes through between the panels? I just want to make sure I don't have leaking.Oh I can help!
I ran the wires down the rack, connected them together with a Y adapter/splice, and then down through the weatherstripping between the second row roof and the rear roof cap. Then ran down behind the trim panel by the rear passenger seatbelt, and connected to the leads ford left there that run up to the glove box. Then connect the line from quarter panel to the line behind glove box so it reaches under the hood. Then under the hood, connect the glove box line to the Aux Switch you select. I grounded the lights back behind the quarter panel trim.
Basically, using Aux 6, you have the following:
The only tricky part with this was behind the glove box, the white/orange didn't have an accessible end because it was jammed in so tightly. So I snipped it, tried to splice one end, and when that didn't work, just connected to the other. If you need help, send me a DM on instagram and I'll be happy to answer more questions.
- Under Hood: Yellow/Orange (Aux 6) splice to either Brown/White or White (two options run to the glove box). I had Brown/White available.
- Behind Glove Box: Brown/White to White/Orange (which runs from glove box to rear passenger quarter panel)
- Behind Rear Passenger QP Trim: White/Orange to the BA-2 positive line.
Consult your manual to be sure your colors are the same as mine. I'm basing this on memory and what I'm seeing when searching online: