Show me your broncos on 37’s…

[Bird Dog Off Road]

Do you have pictures of this gap?

Yep, did a video on it.

Sponsored

 

[Bronco.Dilf]

Yep, did a video on it.

Thanks man. Almost ordered this yesterday on Amazon. Definitely gonna pass

 

[LivingMyVestLife]

Nice. Are you completely level? I have a 1” leveling kit and am still half inch lower.

Yep, seems to be spot on.

 

[Ctal]

37x12.50R17

 

[james1414d]

Eibach coils installed today with Yoko Geo's. Looking like a hot wheels car

 

[StuBobulous]

4" Zone Offroad lift, 37x12.50R20 Falken Wildpeak AT3W's on 20x9 Fuel Flux (0 Offset)

 

[Noremac]

2" over sasquatch with home brew solutions..

 

[killrbeez]

APG Midrunner kit
Rays 05X 17x9 -10mm
Toyo Open Country R/T 37x12.5

 

[Ford Motor Company]

APG Midrunner kit
Rays 05X 17x9 -10mm
Toyo Open Country R/T 37x12.5

Gorgeous bronco! Thanks for sharing!

 

[Ford Motor Company]

4" Zone Offroad lift, 37x12.50R20 Falken Wildpeak AT3W's on 20x9 Fuel Flux (0 Offset)

Love this color! Thanks for sharing your bronco with us, Stu.

 

[Tricky Mike]

 

[BAUS67]

2" over sasquatch with home brew solutions..

Oh do tell. For the rear you probably just redrilled the shock mount higher but you have peaked my interest in the homebrew solution for the front.

 

[Noremac]

Oh do tell. For the rear you probably just redrilled the shock mount higher but you have peaked my interest in the homebrew solution for the front.

lol the front is the cheapest 2” level I found on amazon. It was like $50

 

[Dom]

I’ll play… ‘23 WildTrak
ADS Adj. coil overs @ 2.25” front/1.5” rear and .25” rake. - Talk to @Shifts And Grins Fab
Vorsteiner 17” VR-601BL +0mm offset
37x12.5 Mickey Thompson Baja Boss A/T

I may end up cranking up the rears 2 turns for another .25” as I sag .25” FULLY loaded up for camping etc.

Crashbar mounts (no bars since WT) have not been cut/modified and I DO get a slight rub on crashbar mounts fully flexed (swaybars connected) and steering fully locked. This is the only time and I’ve done quite a lot, even some mild jumping, and no issue otherwise. I may do some minor notching on those mounts at some point, but not a big issue currently.

Where did you get that stripe that runs the length of the rig? I love it!

 

[Chritaka]

Where did you get that stripe that runs the length of the rig? I love it!

Thanks! The top one is from @Underground Graphics and I added my own touch with their hash marks. They were a PITA to line up perfectly on top of that stripe!

The bottoms one is the factory Wildtrak one, but I cut off the mountains on the end….

Sponsored