Soft Top Help

[bschack]

To go from hard top to soft top….are all of the necessary parts sourseable from the soft top donor? Or must some be purchased separately ?

Sponsored

 

[BroncoDymond88]

Yes, everything you need for the soft top is not needed for the hard top. Brackets and trim are all different.

 

[deuberj]

I called Ford to order a couple of these parts and the part number on back is not the part number they order from. Attached is the full diagram of soft top parts with the correct part number for each one

 

[Sgilson]

I also just purchased a soft top from another member here. The long brackets are already on your Bronco but you’ll need the short brackets over the rear seats. I think these bolt down with the same bolts used on the hard top. You’ll also need the two clips that hood down the rear base of the soft top that allow for the tilt up function. I need to go to the hardware store and get the six 13 mm bolts for the soft top frame. They’re the same size as the other hardtop torx head bolts (M8 1.25).

I think all of the hardware can be left installed under the hard top also making the swap even faster the next time.


This Is everything needed except for the 6 bolts.

Great Post! Know size information for these bolts?

 

[BroncoDymond88]

Ahh I don't know, I just purchased the ones I needed from Ford. Sorry bud!

 

[Tacoman]

Going to attempt the switch over from hard top to soft top this weekend after picking up a new, still strapped to plastic pallet, OEM sift top as part of someone's dual top they didn't want. Hope all trim pieces as well as bolts are in the box that is strapped in to top pallet!
Not sure of that bracket midway on a Braptor though since i have an extra brace/cross roll bar over front head rests...

 

[Roll Tide!]

Going to attempt the switch over from hard top to soft top this weekend after picking up a new, still strapped to plastic pallet, OEM sift top as part of someone's dual top they didn't want. Hope all trim pieces as well as bolts are in the box that is strapped in to top pallet!
Not sure of that bracket midway on a Braptor though since i have an extra brace/cross roll bar over front head rests...

How did the install go? Were all the parts included or did you have to source parts?

 

[SeaRock]

Great Post! Know size information for these bolts?

Does anyone know the part number for the 6 torx bolts that are circled in this post?

 

[MNBigfoot]

Anyone have an estimate of total cost of the parts needed?

 

[alexraw]

I called Ford to order a couple of these parts and the part number on back is not the part number they order from. Attached is the full diagram of soft top parts with the correct part number for each one

Do you happen to know which part number are for the two brackets and clips?

 

[cynicalrider]

How did the install go? Were all the parts included or did you have to source parts?

I know it's old but for what it's worth I got dual tops and currently am in the process of selling the soft top. The only things I need to pull from my truck are the two clips for the soft top pop up function and the brackets over the windows. I saw that the trim panels are already in the packaging.

 

[NickOhio]

You also need to remove the 2 brackets and bolts where the main assembly of the soft top attaches to the body. That is not conveyed in this thread, but I just went thru this. And also trade the 2 interior trim pieces that cover that assembly. This thread is more complete.

https://www.bronco6g.com/forum/threads/soft-top-hard-top-swap-tips-lessons-learned-updated.35246/

Sponsored