- Thread starter
- #1
Well after almost 4 months of waiting I got my new rear bumper. I looked far and wide for a rear bumper with a decent swing out to carry that 37"M/T. Gotta get that tire off the body just ask any bronco owner about the old swingouts. Almost every one I looked at had a frame to body connection (that's a no no) So I found SRQ and they had what I was looking for. A nice swing out and even an option of the duel swing outs with jerry can rack and small table inside. They even build the bumper in a modular design so you can build as money allows.
It didn't me take long to figure how to mount my 60" Hi lift on it.
So far I have not relocated the Camera because I cant figure out how the remove it from the stock mount? Anyone have any ideas?
I really like the locks that lock the swing outs in the open position they also lock closed
features of their bumper are:
LEFT SIDE
jerry (NATO) can mount I did a 20L fuel and a 20L H20
small fold down table .
plenty of room for other goodies
RIGHT SIDE
Big heavy duty very adjustable tire carrier
provisions for the 3rd B light
BUMPER
factory integrated led back up lights
Relocated Camera to bottom center above the hitch
Nice heavy D ring mounts
Sensor holes pre drilled
It didn't me take long to figure how to mount my 60" Hi lift on it.
So far I have not relocated the Camera because I cant figure out how the remove it from the stock mount? Anyone have any ideas?
I really like the locks that lock the swing outs in the open position they also lock closed
features of their bumper are:
LEFT SIDE
jerry (NATO) can mount I did a 20L fuel and a 20L H20
small fold down table .
plenty of room for other goodies
RIGHT SIDE
Big heavy duty very adjustable tire carrier
provisions for the 3rd B light
BUMPER
factory integrated led back up lights
Relocated Camera to bottom center above the hitch
Nice heavy D ring mounts
Sensor holes pre drilled
Sponsored