Deleted member 32220
Guest
Sorry to see you guys still having issues, I think there will be 2 more broncos “abandoned” the dealer will love me. “Yes we don’t have to sell at msrp anymore”
Sponsored
I haven't really messed with it. I did take off the top panel and tried to force the gasket over a little, but it didn't move much. I may mess with it again today.Where you able to close the gap by moving the back part hard top forward at all? I just noticed I have a similar gap on my passenger side as well.
Wtf!? That looks like it would be totally open along the back edge! By a 1/2" or more.Anyone else have a gap like this on their two-door hardtop? It looks pretty janky, I can see all the way through it about a quarter to half an inch wide.
You can look through it and see the inside of the rooftop.... I think it's going to take lifting the hardtop off and then adjusting the whole gasket over. Makes me question the long-term quality of that gasket though...Wtf!? That looks like it would be totally open along the back edge! By a 1/2" or more.
I'm also thinking/hoping this as well. I probably won't be able to give it a try until this next weekend though.I think it's going to take lifting the hardtop off and then adjusting the whole gasket over.
I'll probably attempt it Tuesday, will post back when I do.I'm also thinking/hoping this as well. I probably won't be able to give it a try until this next weekend though.
I just looked at mine, MY23 BL, and it looks exactly like yours. I have not done the flashlight test but you bet I'm going to do that after work. Might explain that extra little bit of wind noise I hear from that location.Mine isnt quite so bad but the misalignment really bothers me. I can however put a flashlight on the outside to that rear corner spot and see light on the inside.
I just looked at mine, MY23 BL, and it looks exactly like yours. I have not done the flashlight test but you bet I'm going to do that after work. Might explain that extra little bit of wind noise I hear from that location.
Full disclosure, I used to be a supplier rep. engineer in a Ford Plant and worked closely with the NVH engineer so I know the difference between "wind noise" from leaks and "wind noise" from a brick-shaped vehicle going 60 mph down the road. I will investigate.
Cheers,
WC