- Thread starter
- #1
Anyone have any intel or seen any videos of some shifting action on the 7MT to see what kind of throw length we are looking at?
Sponsored
I saw them drive in person in CO. Looked smooth but it was hard to tell the throw lengthAnyone have any intel or seen any videos of some shifting action on the 7MT to see what kind of throw length we are looking at?
I was driving an old c50 grain truck during harvest this season. I forgot how long the throw is on those rigs. I'd nearly have to get out of the seat to shift into third.I'm sure it's nothing like the '64 one ton I learned on.
Good call, that's right. I am too dumb to remember these things unless people remind me.I think in that video about the manual Sasquatch shows Sasquatch shifting it? I not good enough to post it.
That's what I like to hear.I’m guessing it’s a pretty short throw. Shorter than a T18 or a ZF. Given it is raised and the transmission is up in the body a bit, it’s likely to be decently short.
You could also get an extended shift knob. The throws on my track car are short, but the knob is placed higher for ergonomics.I might have to put on a longer shifter shaft. Been thinking about it for a while. It looks really tiny, like 6 inches tall. We'll see
I like a little height on the shift in a truck
From the ride along video -Anyone have any intel or seen any videos of some shifting action on the 7MT to see what kind of throw length we are looking at?