OP
OP
Deleted member 49144
Guest
- Thread starter
- #16
thanks a lot !! But Jesus , all that for a 1x6 panelRemoval
NOTE: Removal steps in this procedure may contain installation details.
NOTE: Left hand side shown, right hand similar.
- Loosen the rearmost fender flare-quarter turn fastener and position out the wheel moulding.
- Remove the pushpins from the inside trim panel.
- Remove the lower trim piece by disengaging the retaining tabs. Pull from the inside edge first, then pull from the outside edge.
- Remove the lower retaining bolt from the inside trim piece. Pull on the lower part of the trim piece to disengage the upper retaining clips.
Sponsored