Wire management tips/suggestions?

[helifino16]

I make a Junction Box for the Upfitter Switch Connections. It uses WAGO 20A lever connectors for switches 2-6 and a 30A for Switch 1. I mounted to an unused ground wire Rivnut (apparently used on Lux package unfortunately) so I'm working on a version that mounts using the 'racetrack' hole to the right. Still a bit in development but I've been using it for several months.

Just saw a posting mentioning this. This is a GAME CHANGER! So cool!
I didn't look through all the posts, are you selling these yet? Prices? Links to purchase?

Sponsored

 

[Area51BS]

I believe there is only one way to do the wiring properly if you want clean wiring. Tying up extra somewhere is not the answer. Not wrong, just not the best. Cut the light harnesses and add new wire of proper lengths. You can temporarily run them and bundle them with small ties or tape. Then remove and wrap in Tesa tape followed by braided sleeve. Heat shrink ends of braid or cut with a hot knife or heated razor blade. I find it fun and rewarding to do a really nice wiring job. It will also be trouble free if terminated properly.

 

[Dirtrider]

Just saw a posting mentioning this. This is a GAME CHANGER! So cool!
I didn't look through all the posts, are you selling these yet? Prices? Links to purchase?

I'm retired and don't have a business but I will sell one or two direct. I'm asking $50 plus about $12.65 shipping via USPS small flat rate. I'm traveling and won't be home until the end of May but I do have 5 with me and could probably send one to you in the next week or so if you are interested. Pictured

are the colors that I have with me. If you have a Raptor, the switch currents are different so the cover plate and switch order is a little different. I have three cover plates for the Raptor shown in the front of the picture. If you are interested send me a direct message with your shipping address.

Sponsored