Sponsored
Post your 2.3L Bronco Ford Performance Calibration Tune review
- Thread starter LethalPerformance
- Start date
- Watchers 54
- First Name
- Scott
- Joined
- Mar 27, 2023
- Threads
- 23
- Messages
- 463
- Reaction score
- 795
- Location
- Saratoga Springs NY
- Vehicle(s)
- Chevy LT Trail boss
- Your Bronco Model
- Badlands
I have a Sunoco station close to my house that has 94 Octane.. With the tune and this gas I definitely can notice the difference from stock.. Very happy with the results.
@LethalPerformance
Was going to order off the site, but wanted to see if you heard of any issues with running this with the Pedal Commander? Can you run both at the same time? Any insight on this would be helpful. Thanks!
- First Name
- Duston
- Joined
- Jul 7, 2022
- Threads
- 4
- Messages
- 17
- Reaction score
- 12
- Location
- South Florida
- Vehicle(s)
- BMW 535i GT
- Your Bronco Model
- Black Diamond
While it hasn't been tested, I don't see any issues running the Pedal Commander on top of the FPP tune. That being said the FPP flash increases throttle response as well, so the commander may end up being redundant depending on how much you're increasing the sensitivity already.
Wish I would have seen this sooner. I just put rough country speedometer calibration on ‘23 2.3l base. Can you run this with that installed?
Sponsored
- Joined
- Dec 11, 2022
- Threads
- 10
- Messages
- 281
- Reaction score
- 469
- Location
- Los Angeles
- Vehicle(s)
- 5 early broncos, AGM Everglades
- Your Bronco Model
- Everglades
I keep getting an error code and this is through the dealership. Any advice?
I also have an 23 everglades on the way and wondering if the tune will work.I keep getting an error code and this is through the dealership. Any advice?
- First Name
- Duston
- Joined
- Jul 7, 2022
- Threads
- 4
- Messages
- 17
- Reaction score
- 12
- Location
- South Florida
- Vehicle(s)
- BMW 535i GT
- Your Bronco Model
- Black Diamond
Yes, I don't see why not, but it will also be redundant. I'm not sure if the Ford flash would overwrite that or not, maybe a ForScan expert can chime in.
- First Name
- Bud
- Joined
- Aug 18, 2021
- Threads
- 9
- Messages
- 78
- Reaction score
- 34
- Location
- tallahassee
- Vehicle(s)
- bronco
- Your Bronco Model
- Base
- Banned
- #204
Tune review. This is a very mild tune. I would be suprised if it netted 15 hp to the wheel. Someone with a youtube channel should dyno. Mileage still seems to suck. Have some lighter weight method 318s on the way so hopefully that will help.
The below error means you need to update software because your SN is not in the software you have loaded.
The below error means you need to update software because your SN is not in the software you have loaded.
I keep getting an error code and this is through the dealership. Any advice?
OP
OP
- First Name
- Jared
- Joined
- Jul 14, 2020
- Threads
- 210
- Messages
- 1,260
- Reaction score
- 1,860
- Location
- South Florida
- Website
- www.lethalperformance.com
- Vehicle(s)
- 2020 First Edtion 2.7L / 2020 Shelby GT500 CF
- Your Bronco Model
- Raptor
- Thread starter
- #205
If you're not in CA then it will work. CA vehicles won't be able to receive the Ford Performance calibrations until they receive approval from CARB.
Sponsored
- Joined
- May 2, 2023
- Threads
- 3
- Messages
- 665
- Reaction score
- 1,929
- Location
- Big Sky Country
- Vehicle(s)
- Triumph Scrambler, Ferrari 458
- Your Bronco Model
- Badlands
Because the atmosphere within the engine bay of your Bronco has completely collapsed and you're running on pure dark matter.
- First Name
- Ben
- Joined
- Jul 30, 2022
- Threads
- 0
- Messages
- 18
- Reaction score
- 26
- Location
- Brooklyn, NY
- Vehicle(s)
- 2012 Jeep Liberty Latitude
- Your Bronco Model
- Wildtrak
I think that because it's VIN-locked, Ford cross references your VIN with your registration and won't allow the software to upload onto the box until CARB approval.
Similar threads
