- First Name
- David
- Joined
- Aug 19, 2021
- Threads
- 5
- Messages
- 74
- Reaction score
- 125
- Location
- Pennsylvanian
- Vehicle(s)
- Chevy Traverse
- Your Bronco Model
- Undecided
Yep. Now I have switched power in the center of my vehicle to continue running more lighting in the rear, which is in the works now. Also much easier to do it my way.
The lights go off in two directions from the control module. One for the left, one for the right.
You can either avoid the middle hump between driver and passenger by routing it the way I did, or do the opposite - route it through the dash, and have to deal with taking apart the lower dash on both sides to snake wires over the hump between driver and passenger. It's pretty crowded with the Lux package.
The only change would be that I did more work (but it would require less supplies), and I still have to run power to the same area as my current method for the additional lighting going in.
Nothing wrong with doing your idea though. Just not the method I would go with personally (obviously). I always try to err on the side of what could be beneficial long term, and a new power source mid vehicle is worth it's weight in gold.
Make sense now, power tap is there to expand more lighting to the rear for future use.
I ordered a set if govee, and reviewed your thread again to preplan the setup and was wondering if you came into something that made you install them this way.
Thank You
Sponsored