- Joined
- Jun 4, 2020
- Threads
- 3
- Messages
- 894
- Reaction score
- 2,119
- Location
- Austin, TX
- Vehicle(s)
- F150
- Your Bronco Model
- Undecided
Still, isn't inspiring.
Sponsored
Don't tell that to Mustang owners, V6 in past or ecoboost have no emblems=no holes, but all GT's for years have holes in the fender for the GT or 5.0 emblem. My GT350 emblems have locating holesI doubt it. The base gets no badge. They’re not making two types of fenders for a badge. Also, modern glue stays put. No need for holes.
Use a heat gun or a hair dryer to warm them up and pull them off. Might need a little goo-gone to clean it up.how hard/easy do you think to pop off?
Little heat fron hair dryer and a piece of fishing line?how hard/easy do you think to pop off?
Not sure if I'd want to buy anything like that until I actually place a vehicle order, though, as I could wind up changing trim levels.I'm also kind surprised we haven't seen any merch with the trim badging.
I mean, they've already got an Amazon store up and running. With the way they are marketing these trims, it would seem like a no-brainer to slap those badge graphics on a hat...
Tip, when using fishing line, use your boots instead of your hands. Gloves help but not as much as a Vibram sole.Easy. Fishing line and some Goo Gone.
I tried to get some pics that show the depth of the sticker. It's a substantial hard vinyl sticker. Not a nice metal badge, but not a flimsy sticker either.$0.02: They look to me a little more robust than thin film stickers -- more like a thin aluminum or hard plastic plate with adhesive on the back. They also look like they'd be more of a pita to "floss" off without damaging the fender finish.
When I replaced the chrome 5.0 badges with black ones on our Mustang GT, the backing was a foam-backed adhesive which allowed floss-sawing a little bit away from the fender surface. The Bronco badges don't look as easy.
It's nowhere close to 3.5mm thick. But it's also not flimsy.Most likely 3m graphic film printed vinyl with clear overlay 3.5mm thick. Holds up well to the abuse on dirt bikes.
Maybe I misheard the decimal point (on Mx graphics) lol, agreed they’re not over 1/8” lol I could believe .35mm. I’m sure people could have billet badges make some emblems if there unhappy with the decal.It's nowhere close to 3.5mm thick. But it's also not flimsy.
When I inspected the Bronco at SuperCel West, the badge thickness kinda reminded me of a fridge magnet or a bit thinner.It's nowhere close to 3.5mm thick. But it's also not flimsy.