- First Name
- Kevin
- Joined
- Apr 11, 2021
- Threads
- 22
- Messages
- 838
- Reaction score
- 846
- Location
- Woodbridge, Virginia
- Vehicle(s)
- 2019 Raptor
- Your Bronco Model
- Badlands
And you will be doing the Aux setup? I'll be looking for that video.To be more specific... you just need to connect the up-fitter wire from your Aux switch to the purple wire on the harness that goes to the air compressor. That allows you to control the relay that turns on/off the air compressor from the aux switch rather than the ARB switch.
@BroncoTPA specifically talked about the purple wire in their video because for some reason ARB decided to have red go to purple on the wiring harness connector. But that's the same purple wire that needs to be connected to. If I recall correctly their Outer Banks doesn't have the Aux switch option, so I'm guessing that's why they just used the ARB switch. But the Badlands they ordered will have the switches, so they can just transplant the setup over to the new Bronco when it gets there.
I was planning on doing a video how-to and/or a write-up for the ARB CKMA12 compressor, which is the smaller of the two compressors that can also be bolted into the bracket on the @4x4TruckLEDs.com website, but... need a Bronco first.
Sponsored