Kind wish I would have ordered the winch now so I could just get a fairlead mount.
That looks freaking tacky.
That looks freaking tacky.
Sponsored
The holes are to mount the bracket, not the plate.Those aren't starter holes for the license plate. Not U.S. plates, anyway, which are only 12" wide. The holes would need to be about 11" on center. Maybe you're looking at the Euro-spec Bronco.
It's tough to tell but it looks like those dimples are about 10-11" apart.Those aren't starter holes for the license plate. Not U.S. plates, anyway, which are only 12" wide. The holes would need to be about 11" on center. Maybe you're looking at the Euro-spec Bronco.
Why would the bracket need to be almost 6" wider than the plate?The holes are to mount the bracket, not the plate.
Same thing happened to me!!!Lost my front plate and mount in a boating accident.
(Be fun to see who gets this)
I think the holes are closer than they appear in the photo.Why would the bracket need to be almost 6" wider than the plate?
That just sounds like you need bigger tires for better license plate clearance.It may be too low also. Here in AZ, the bottom of the plate needs to be at least 12 inches above the ground.
What the heck are you talkin' about?Why would the bracket need to be almost 6" wider than the plate?
I believe he was looking at these two points. I could be wrong though.What the heck are you talkin' about?
Those starter dimples are about 10" apart... they certainly are not further apart than 12"... which is how wide a plate is.
You are wrong. The holes are on the body color about 10 inches apart.I believe he was looking at these two points. I could be wrong though.
Why would it be there? That would make the bracket like, 6” wider than the plate.I believe he was looking at these two points. I could be wrong though.
I'm aware, I was saying that I believed that the person you responded to may have been looking at those two points in confusion.You are wrong. The holes are on the body color about 10 inches apart.
Oh, I was looking at the grey part. It looked like there were starter holes at the 1/2" and 17 1/2" marks. Didn't even think to look up at the orange part. What were they trying to measure?What the heck are you talkin' about?
Those starter dimples are about 10" apart... they certainly are not further apart than 12"... which is how wide a plate is.