- First Name
- Bryan
- Joined
- Oct 18, 2022
- Threads
- 8
- Messages
- 470
- Reaction score
- 1,031
- Location
- Brevard, NC
- Vehicle(s)
- 2022 Wildtrak
- Your Bronco Model
- Wildtrak
@HavocOffroad Installed my steel bender rear bumper last night and looks good/super happy with it but ran into one issue you guys might want to consider. It’s set up to use the factory backup sensors/stock harness but the issue is that the two center sensor holes are about 6-8” further apart than they are on the stock bumper. The factory harness won’t allow both center sensors to reach their respective holes without splicing in/extending the wiring on one of those two middle sensors. The outer 2 are great, just the center spacing is too wide for the stock harness
Sponsored