- First Name
- Billy
- Joined
- Jul 19, 2020
- Threads
- 2
- Messages
- 15
- Reaction score
- 120
- Location
- Arkansas
- Website
- farmerjack.com
- Vehicle(s)
- 2017 f250
- Your Bronco Model
- Badlands
- Thread starter
- #1
First off I want to thank @flip for the hitch and trailer brake controller.
Parts I purchased for this install.
1- Bronco Raptor hitch
2- captured 3/8 nuts
1- Borla muffler 2.5 offset/center
1- 3” stainless j bend pipe
I haven’t seen any info on this yet, and I thought I would share. Short story is I removed factory hitch, removed rear muffler. Then I installed Borla muffler midship and built new tailpipe. Also built temporary kicker bars until oem braces become available. The factory crossmember has spots for captured nutrecommend m10’s but I only had one in the tool box so I used 3/8 nuts until I change the braces out. Sorry in advance for terrible pics. Lol
I hope this helps anyone that is thinking about doing this.
Parts I purchased for this install.
1- Bronco Raptor hitch
2- captured 3/8 nuts
1- Borla muffler 2.5 offset/center
1- 3” stainless j bend pipe
I haven’t seen any info on this yet, and I thought I would share. Short story is I removed factory hitch, removed rear muffler. Then I installed Borla muffler midship and built new tailpipe. Also built temporary kicker bars until oem braces become available. The factory crossmember has spots for captured nutrecommend m10’s but I only had one in the tool box so I used 3/8 nuts until I change the braces out. Sorry in advance for terrible pics. Lol
I hope this helps anyone that is thinking about doing this.
Sponsored
Last edited by a moderator: