This the same one I used.
Sponsored
This the same one I used.
Thanks fam Iām going to check the manufacture Iām running ko2s. Glad to have you guys to run ideas by.Tarikh, most 35s arenāt exactly 35.0ā in diameter. For example, Sasquatch tires (LT315/70 R17) are 34.4ā diameter, so the circumference for that tire would be 2741 mm. Not a big difference between 2741 and 2791, but itās still smaller. So be sure to use your exact tire diameter, and not the nominal diameter marketed by the tire maker. Might as well be exact, if you can.
Source: 2021 Bronco Factory Tire Size & Wheel Size Comparisons (Circumference, Diameter, Height, Width, Bolt Pattern, Center Bore)
Donāt want to give the impression that this is my video. Iām not brave enough to try this myself at this point. I am just happy to see a shade tree up-fitter can accomplish this so easily. As far as the fog lights.... I would think forscan would be unnecessary. If wires are there I would think a simple switch to connect them should do the trick. But Iāve only worked on 80ās and 90ās vehicles.Awesome thanks for sharing! If you get time can you check to see if thereās an option to enable a fog light button?
We found out the wiring is there for the fogs (even when theyāre missing like on the mod bumper). If it can be enabled on Forscan then all that would be needed is a switch and some aftermarket lights
Thatās what I started at , but after driving it it had went the other direction and speedometer said I was going faster than GPS.My tires are 35/12.5R17 I got 2791 for the circumference. Am I right guys?
Iām going from base tires.
Thank you. Iām on YouTube thanking you also.Thatās what I started at , but after driving it it had went the other direction and speedometer said I was going faster than GPS.
Dialed it back a little at a time until I ended up at 2600mm which is less than actual tire circumference but what gets everything synced up.
Just wondering if anybody has tried to calibrate there speedo with Forscan. I did mine and when I changed my tire circumference to proper size i went from reading under to over my actual speed and lost my cruise control. I have the 2.3L with a manual transmission so Iām just wondering if anyone has a solution for this.
Went smoothly did get some codes but once I ran PCM and AWD relearn and cleared DTC. they stayed away.@evilletruck did the step through to do this work smooth for you? Any other gremlins jump out during the process?
Just wondering if anybody has tried to calibrate there speedo with Forscan. I did mine and when I changed my tire circumference to proper size i went from reading under to over my actual speed and lost my cruise control. I have the 2.3L with a manual transmission so Iām just wondering if anyone has a solution for this.
AftSame happened to me, had to dial the number back incrementally ( did @ 100 mm ) each time until it all synced up, started at 2792 went to 2691, and then 2600 which was right on.
After you found the right number was your cruise still working fine or did you have to do anything else.Same happened to me, had to dial the number back incrementally ( did @ 100 mm ) each time until it all synced up, started at 2792 went to 2691, and then 2600 which was right on.
Aft
After you found the right number was your cruise still working fine or did you have to do anything else.